1. Whether the laser resonator changes; Fine tune the resonator lens. Make the output light spot best;
2. The acoustooptic crystal is offset or the output energy of acoustooptic power supply is low; Adjust the position of acoustooptic crystal or increase the working current of acoustooptic power supply;
3. The laser entering the galvanometer deviates from the center: adjust the laser;
4. If the current is adjusted to about 20a and the sensitivity is still not strong enough: the krypton lamp is aging, replace it with a new lamp.
Laser cutting machine metal sheet laser cutting process 2023-12-01
Various metal sheets such as copper foil and aluminum foil are widely used in electronic 3C and semiconductor integrated circuit systems such as battery pole pieces, capacitors, and circuit boards due to their good thermal and electrical conductivity. These are highly precise in…
Femtosecond laser cutting machine semiconductor test socket production process 2023-11-28
Femtosecond laser cutting machine is a type of cutting machine, but it has the best cutting technology among laser cutting equipment. It is a must-choice for cutting high-quality products in terms of cutting quality and cutting speed. Femtosecond laser cutting machines are used …
Detailed explanation of the vascular stent cutting process of femtosecond laser cutting machine 2023-11-24
At present, the use of cardiac stents in China is very mature. With the widespread application of cardiac stents, the production quality of domestic stents is getting better and better, which is inseparable from the advanced technology and technology of domestic laser cutting ma…
Circuit board laser cutting machine and flexible copper clad laminate laser cutting process 2023-11-21
Flexible copper-clad laminate is a copper-clad laminate formed by bonding one or both sides of a flexible insulating material such as polyester film with copper foil through process treatment. It is also called a flexible copper-clad laminate. It is widely used in various electr…